QUALITY AND PERFORMANCE

Quality and Performance

Quality and Performance

The world of toy flying toys provided was not overrun with radio-controlled devices using the latest infrared technology. Toy flying toys have been relatively simple in design for centuries, long before man ever actually flew in a machine. If you like working with wood and traditional construction toys that fill a child with imagination, instead of filling landfills with batteries, learn to make traditional toy flying toy.

Soak the tongue depressor in boiling water for at least 30 seconds. This will make the wood a little more flexible to shape a rotor. Remove the tongue depressor of water with a pair of pliers, and try to twist the stick in the center. You want to try to advance a lateral shift while turning back the other side. Hold the position while the tongue blade cooling. You may have to repeat this step several times. Ideally, the depressor is formed has a half angle. If you have trouble bending the wood, try using a file at least the angle of the edges.

Apply a small drop of glue to the pencil eraser, and then paste in the center of the tongue depressor. Get it as close to dead center as possible, as this will affect the balance. You can also use a pencil and a tape measure and mark the exact center, but one eye-ball is perfectly acceptable. Instead of a pencil, a 1/4-inch dowel rod, about 7 to 8 inches long, will provide a good balance on the toy flying toy.

Decorate your flying toy. The use of different colored felt-tip color of your toy flying toy with a color and design of your choice. Color of the rotor blade at least.

Wrap thy sting tightly around the pencil, about one third of the distance from the top of the toy flying toy. Use a piece of kite string or nylon cord. A piece of 12 to 18 inches long is perfect. Simply wrap the string around the pencil several times, leaving a bit at the end so that you may have.

Cut a piece of aquarium tubing that is 3 or 4 inches long, enough to hold on to. The tube must have an inside diameter that is large enough for your pencil loosely placed inside, with lots of extra space. Use a knife or a small drill to make a hole in one side of the tube, near one end. The hole should be big enough for kite string to pass through.

Place the tube so that the end with the hole is at the top, and slide the stylus in it. Where the party at the rope that wrapped around the pencil is in the pipeline, go the extra length of the end of the string through the hole so the string can be pulled, even though the package is inside the tube .

Hold the handle of the toy flying toy with a hand, yanking the chain of good relations with ...