CONSTRUCTION

Construction

Construction

Introduction

Describing the likely cause of the damage to the windows

The main cause of damage to window frames as reported in the survey is that the wooden frames absorbs moisture and swells. A sure sign that the wooden window frames contains excessive moisture is the paint to peel. In the long run becomes the constant moisture also the direct cause of the wood may rot and start to decay. Whether you are going to use planer, chisel or just sandpaper when to adjust the window, it is important that you be patient and cautious approach. It is better to take very little at a time and try fit repeatedly, than to risk taking too much and get a big, ugly run instead. So make sure you have gone about your time at this type of job.

The most annoying cases in case of damage to window frames are jam, but it's not the only reason that you should investigate the cause and correct the errors. If the wood in the window frame is cracking, the wood will absorb moisture and swell. Thus, this window becomes skewed and can be difficult if not impossible to open and close. Wood's fitness is not the only reason windows jamming. Another reason may be that both windows and arch painted with latex paint.

Analysing remedial remedies i.e. repair

Repairing wooden window frames is very easy and, once repaired, will last for years. Remove the rotten wood of the window with a screwdriver or wood chisel, remove as much of rotten wood as possible. If adheres rotten wood around the edges, and the rotted section is mixed with sound wood, use a hammer to hit the bottom of the tool to help take off the wood until you remove all the rotten.

Filling with putty, sanding and painting, the frame will be looked like new. If the wood rot has affected a larger area, it's best to replace an entire section of the window frame. It is better to err by removing wood in good condition to fall short and leave part of rotten wood. Try to make the edges of the opening as straight and square as possible and then clean the work area thoroughly with a brush or vacuum cleaner.

Moist, warm air is on the inside, while rain, snow, wind, heat and cold alternately plunges from outside can have ever-changing and challenging conditions which makes the wood surface quickly damage. In order to avoid sticking window, it is necessary to review them periodically.

When the glue comes off from the fold, you should as soon as you can putty on the window. Scrape away all loose putty and oil or prime the rim, the mass must then dry completely before you can paint cat edge. Drying time can vary between a few days and several weeks. It is often advisable to repaint the entire window when omitting. Cleaning of the window thoroughly with scraper and sandpaper is required.

It is required to check that the hinges ...